The link you selected is for a destination outside of the Federal Government. CPSC does not control this external site or its privacy policy and cannot attest to the accuracy of the information it contains. You may wish to review the privacy policy of the external site as its information collection practices may differ from ours. Linking to this external site does not constitute an endorsement of the site or the information it contains by CPSC or any of its employees.
No image available. Recall Date:. Name of Product: Log Splitters Units: About 26, in the United States and 2, in Canada Manufacturer: MTD Products Inc, of Cleveland, Ohio Hazard: The control handle of the log splitter could fail to automatically return to the neutral position as it should and could fail to stop the splitting wedge from moving forward, posing a risk of amputation to consumers' hands and fingers. Related Recalls. The end cap of the log splitter's hydraulic cylinder can break away from the body of the log splitter, posing an impact hazard to the user or bystander.
In cooperation with the U. Quick Links. Table of Contents. Previous Page. Next Page. Page 2: Table Of Contents Visit us on the web at www. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury.
Page 4 If your machine is equipped with an internal combustion Never fuel machine indoors. Page 5: Maintenance And Storage When splitting in the vertical position, stabilize the log Do not alter this machine in any manner, alterations such before moving the control handle.
Split as follows: as attaching a rope or extension to the control handle, or adding to the width or height of the wedge may result in Place log on the end plate and turn until it leans personal injury.
Page 6 Safety Symbols This page depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Remove the spring clip and clevis pin from the jack stand Use extreme caution unpacking this on the tongue and then pivot the jack stand towards the machine. Page 8 Align the holes in the tongue with the holes in the tank Disconnect the dislodger from the beam weld bracket by bracket and secure with the hardware just removed.
See removing the six hex screws. See Fig. NOTE: The high pressure hose, which runs from the gear pump to the bottom of the control valve, must be above Hex Screws Page 9 Check for and remove any staples on the bottom of the Lift and slide the cylinder up to the top of beam and into crate that may puncture the tire. Page 10 Set-Up Check the fluid level using the dipstick. Do not overfill. Recoil Starter Assembly.
Spider Coupling Bushing. Air Filter Kit. Model: 24BG57M Form Number: E. View Options: PDF. Form Number: F. Form Number: Form Number: B.
0コメント